Uncategorized

How to Build a Smok Pen


How to Build a Smok Pen

The Smok Pen is really a revolutionary vaporizing pen that allows for a write-to-write experience, whilst you are away from home. This is because of the unique design of the pen. It has two tanks, one smaller compared to the other, that house the e juice and charged batteries. Once the user really wants to write, he just places the pen into the smaller tank and places the ink in the chamber where it will be vaporized. He simply turns on the pen and writes as though he is writing under a black mirror.

smok pen

One of the biggest attributes of the Smok Pen is its capability to charge while it is on your desk. This is due to the coils on the Smok Pen were created in a way to keep the e juice from dripping onto the table or somewhere else. This is because of the 0.3-ohm coil that’s placed in the Smok Pen. The 0.3-ohm coil means that even the slightest of air currents won’t affect the writing process. Simply because the electronic circuitry has protection built-in so that it will never be suffering from extremely low voltage electric currents.

The Smok Pen can be charged internally with a charger or via the USB connection that is included with it. Since the electronic circuitry has a safety barrier built in, which means that there is no risk involved when charging the device through the computer. The Smok Pen Vape includes a charging capacity of sixteen 50 mah batteries, which is ideal for all pens that use a couple of batteries.

To keep the Smok Pen working for an extended time period it is important that you don’t overcharge the battery. Overcharging the battery will certainly reduce the voltage that is available and may eventually bring about these devices malfunctioning. Overcharging the Smok Pen could also affect the vaporizing process. If you feel that your battery isn’t getting the vapor it will, remove the pen from the power source and let it cool off for a few minutes.

The fire button on the Smok Pen is located in the bottom right corner of the device. The fire button has an orange light, which indicates that it’s on. It is possible to press this button to activate the electronic heating element that will permit you to vaporize the oil. Once you have done so you can take away the coil from the holder and stick it in to the holder and place the Smok Pen into the airflow chamber, that may cause the heating element to start heating up and burning away the wick.

Once the coil is taken off the holder the airflow chamber is ready for the sub-ohm cartridge. The coils are put inside the holder plus they get heated from the airflow. Once they get hot they begin to turn blue, that is the indication that it’s ready for the pen’s battery. Ensure that you place your sub-ohm into the chamber before you push the fire button. If you don’t put the coil in to the airflow chamber then your oil will leak and cause the leaking of e-juice.

Before you put the battery in to the pen, you must ensure that you have disconnected all the leads. Then you have to take out the Smok Pen’s cap and locate the leak or drip tip. You must clean this with a little cotton bud, to be able to eliminate the leak. Then reattach the cap back to the Smok Pen and you also are prepared to place the battery into the pen.

The final section of the construction process may be the adapter plate, which fits into the Smok Vaporizer’s USB port. This plate enables you to charge your e-juice through your computer, so long as you have an adapter for USB connection. I like this part since it allows me to charge my entire kit simultaneously without fretting about running out of power or constantly running out of e-juice.

Close