Uncategorized

How to Build a Smok Pen


How to Build a Smok Pen

The Smok Pen is a revolutionary vaporizing pen that allows for a write-to-write experience, even while you are abroad. This is because of the unique design of the pen. It has two tanks, one smaller compared to the other, that house the e juice and charged batteries. Once the user really wants to write, he just places the pen in to the smaller tank and places the ink in the chamber where it’ll be vaporized. He simply turns on the pen and writes as if he is writing under a black mirror.

smok pen

One of the biggest attributes of the Smok Pen is its ability to charge while it is on your own desk. For the reason that the coils on the Smok Vape Pen were created in a way to help keep the e juice from dripping onto the table or somewhere else. This is because of the 0.3-ohm coil that is placed inside the Smok Pen. The 0.3-ohm coil means that even the slightest of air currents will not affect the writing process. This is because the electronic circuitry has protection built in so that it will not be affected by extremely low voltage electric currents.

The Smok Pen can be charged internally with a charger or via the USB connection that comes with it. Since the electronic circuitry includes a safety barrier built in, because of this there is no risk involved when charging the device through the computer. The Smok Pen includes a charging capacity of sixteen 50 mah batteries, which is great for all pens that use a couple of batteries.

In order to keep the Smok Pen doing work for an extended period of time it is important that you do not overcharge the battery. Overcharging the battery will certainly reduce the voltage that’s available and may eventually result in these devices malfunctioning. Overcharging the Smok Pen could also affect the vaporizing process. If you feel that your battery is not getting the vapor it will, remove the pen from the power source and let it cool off for some minutes.

The fire button on the Smok Pen is situated at the bottom right corner of the device. The fire button comes with an orange light, which indicates that it is on. You can press this button to activate the electronic heating element that may permit you to vaporize the oil. After you have done so you can remove the coil from the holder and stick it into the holder and place the Smok Pen in to the airflow chamber, that will cause the heating element to start out heating up and burning off the wick.

Once the coil is taken off the holder the airflow chamber is ready for the sub-ohm cartridge. The coils are placed inside the holder and they get heated from the airflow. Once they get hot they start to turn blue, which is the indication that it’s ready for the pen’s battery. Make sure that you place your sub-ohm in to the chamber before you push the fire button. If you don’t put the coil in to the airflow chamber then your oil will leak and cause the leaking of e-juice.

Before you put the battery in to the pen, you must make sure that you have disconnected all the leads. Then you need to take out the Smok Pen’s cap and locate the leak or drip tip. You need to clean this with a little cotton bud, so that you can eliminate leak. Then reattach the cap back to the Smok Pen and you also will be ready to place the battery in to the pen.

The final section of the construction process may be the adapter plate, which fits into the Smok Vaporizer’s USB port. This plate allows you to charge your e-juice through your computer, as long as you have an adapter for USB connection. I like this part as it allows me to charge my entire kit at once without fretting about running out of power or constantly running out of e-juice.

Close